| Products > 3D printing |
| Printing issue - offset on X or Y after 7hrs printing |
| << < (4/5) > >> |
| Rax:
--- Quote from: MarkF on November 17, 2024, 03:05:40 pm ---I understand your Ender 3 is capable of much higher print speeds? --- End quote --- I think, in theory, it should. But I'm not seeing anything distinctly faster relative to my old Ender 3 Pro, though maybe I have to mess with the settings more. I'll also try a third party slicer (the Creality Slicer 4.8.2 seems indeed to be a Cura offshoot). |
| Rax:
There's some oddness to the temperatures as the printer runs them - for instance (though I need to take a closer look to verify this) but it seems the printer starts the printing at a lower temperature than the 210 I generally set it at for my PLA (I tend to use Microcenter's own PLA, in large part as I like to buy locally to keep them open...). Some maybe there's some variation on how the printer does it vs. what the gcode sets?... |
| Rax:
On the topic of slicers - there have been some mentions here for some alternative programs, but what has worked particularly well for some of you here, for say, an Ender? BTW - even if the Creality Slicer may have been created on top of the Cura engine (which is what it sounds like to me from points made here), I'm not finding an "expert" mode for it to run. |
| Rax:
--- Quote from: Rax on November 17, 2024, 04:17:43 pm ---On the topic of slicers - there have been some mentions here for some alternative programs --- End quote --- For instance, I just installed Prusa Slicer, but it doesn't seem to have direct support for my Ender. Though I may be able to run it by finding the "closest match" from the Ender options listed. |
| MarkF:
--- Quote from: Rax on November 17, 2024, 04:47:39 pm --- --- Quote from: Rax on November 17, 2024, 04:17:43 pm ---On the topic of slicers - there have been some mentions here for some alternative programs --- End quote --- For instance, I just installed Prusa Slicer, but it doesn't seem to have direct support for my Ender. Though I may be able to run it by finding the "closest match" from the Ender options listed. --- End quote --- I didn't flush the PrusaSlicer for the Ender 3 KE. I saw the basic Ender 3 and that you can configure it for Klipper instead of Marlin on the Printer setup. It will probably take some tinkering to get it working properly. As far as a Expert mode, I was referring to Cura and PrusaSlicer. At the time, I was unaware of the slicer that came with your printer. Remember my experience is with the Creality CR-10 Mini bought in 2018. Some of what I said earlier may be irrelevant to your newer printer and slicer. Klipper is all foreign to me... |
| Navigation |
| Message Index |
| Next page |
| Previous page |