Off Topic Hobbies > 3D printing

SLA 3D Printer yet?

<< < (4/5) > >>

Mr.B:
First test print – Anycubic Photon Mono X
Default settings straight out of the box.
Layer Thickness: 0.05mm
Layer Exposure: 2s
UV Led Intensity: 50%
Z Lift Distance: 8mm
Z Lift Speed: 2mm/s
Z return Speed: 3mm/s
Overall Model Height: 55mm
Print Duration: 3h 21m
Bear in mind that the build volume would allow me to print 12 of these at once and it would take exactly the same time as only printing one.
Now it is a matter of tweaking the above settings to attempt to decrease the total print time and not have any build disasters…

Mr.B:
How do I move this thread to *Off Topic Hobbies » 3D printing*
Or does this have to be done by a Moderator?

beanflying:

--- Quote from: Mr.B on February 21, 2021, 03:34:17 am ---How do I move this thread to *Off Topic Hobbies » 3D printing*
Or does this have to be done by a Moderator?

--- End quote ---

Down the bottom Left. You can leave a notification in this section with a hyperlink to the new one too (good idea)

Now must not buy a Resin Printer to keep my FDM fleet company ....  :-DD

Mr.B:
Thanks Bean.

ricard2k:
I have a XYZ printing Nobel 1.0 for two and a half years now, and I´m pretty impressed with the results.
I used it for Model Railways.


Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version