Products > 3D printing
Stamps
beanflying:
--- Quote from: dunkemhigh on October 12, 2021, 11:42:50 am ---I think it would depend on how you intend to make the physical stamp. For instance, if I am going to use a laser than just creating an image file (jpg, png, gif) would be fine since that's what the laser software can cope with easily. However, if I were going to mill it then I'd need to end up with g-code. For an image I might use Affinity Photo or Designer, for g-code I would probably draw it in TurboCAD and then generate the g-code with SheetCAM.
Of course, what you have sitting around would dictate the precise details for your usage. I suspect someone may be along shortly to suggest something like Fusion 360 :)
[Edit: happened while I was typing...]
--- End quote ---
PRE SNAP :-DD
kosine:
Ink beads off TPU, so won't work. You need something like EVA, SEBS or TPV (e.g. Santoprene). They carry ink quite well.
PlainName:
I've acquired a neoprene (I think) sheet to make the stamp from. Just completely making a laser installation and figuring out speeds and powers...
Navigation
[0] Message Index
[*] Previous page
Go to full version