AD17: Not Fitted components not displaying Red-X on schematic?
AD17: Not Fitted components not displaying Red-X on schematic?
Posted by
Pack34
on 16 Nov, 2017 20:31
Does anyone know what could be causing this issue?
The Red X is not displaying on Not Fitted components on the schematic but the 3D models are correctly being disabled on the PCB.
http://www.altium.com/documentation/16.0/display/ADES/WorkspaceManager_Dlg-VariantOptionForm((Variant+Options))_AD
#1 Reply
Posted by
veryevil
on 16 Nov, 2017 21:19
Hi, you have to have the variant set in the box at the top, you have to have compiled the project and you have to select the litle tab at the bottom of the screen next to where it says "editor"
#2 Reply
Posted by
Pack34
on 17 Nov, 2017 14:55
That's interesting. Thanks!
Are you sure?
Confirm
Cancel
Are you sure?
Confirm
Cancel
Are you sure?
Confirm
Cancel
Are you sure?
Confirm
Cancel
There was an error while thanking
Thanking...
Go to page
:
1
Navigation
Common actions
Home
Login
Register
Search
Recent Posts
Full site
Powered by SMFPacks Advanced Attachments Uploader Mod