Altium design rule verification report does not focus on the specific violation

[electronx]

altium design rule verification report does not focus on the relevant violation. I am using version 24.5.2. WHAT I EXPECTED is for it to jump on the pcb when I press the violation. Is anyone else experiencing this problem?

[thm_w]

Whats your zoom level set set to?

Open the PCB panel and check off Zoom and look at Zoom Level: https://www.altium.com/documentation/knowledge-base/altium-designer/pcb-panel-selection-and-highlight-controls

You can try using messages instead of using the report too, it should be the same though.

[tooki]

altium design rule verification report does not focus on the relevant violation. I am using version 24.5.2. WHAT I EXPECTED is for it to jump on the pcb when I press the violation. Is anyone else experiencing this problem?

I’ve had the same problem for quite some time. The links simply don’t work. For me this has been the case for a while, on multiple computers. I know it did work several years ago.

The links in the Messages panel do work, though!

[electronx]

Maybe if someone who works with x86 changes the drc file, it can return to its previous state.

[tooki]

Maybe if someone who works with x86 changes the drc file, it can return to its previous state.

????