Electronics > Altium Designer

Altium scary export: ODB++ and GerberX2 are different :(

(1/2) > >>

frogblender:
I'm running the project releaser on Altium 21.5.1, and it outputs both ODB  and GerberX2.

But the ODB is missing some via pads (see attached).

Any ideas why?     This is worrisome.....

Pseudobyte:
I've had issues with certain gerber viewers displaying ODB++ incorrectly, namely ViewMate.

frogblender:

--- Quote from: Pseudobyte on September 21, 2021, 07:34:40 pm ---I've had issues with certain gerber viewers displaying ODB++ incorrectly, namely ViewMate.

--- End quote ---

In my case it is the odb++ at fault;  the viewer seems fine (I'm using is the Mentor aka Valor aka Siemens free odb++ view;   I am too cheap to spring for the Viewmate version which can view odb++)

Gribo:
The free version of Pentalogix Viewmate opens ODB++

frogblender:

--- Quote from: Gribo on September 23, 2021, 04:25:03 pm ---The free version of Pentalogix Viewmate opens ODB++

--- End quote ---
Are you sure?   This page seems to indicate the odb++ version is $95:  https://www.pentalogix.com/t/software-products/viewmate

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version