Electronics > Altium Designer

Auto spacing tracks after routing


is there a way to space traces evenly after routing manually a PCB?

I tried glossing but it kind of does it but it does not have any settings and it often pushes traces very close to each other when there is no need to.

Thank you

I'm fairly certain Altium has no spreading tool.
The best I can think of would be to have two clearance rules - one for "minimums" and one for "preferred" - and selectively enable and disable them depending on the task at hand.
Alternatively get creative with rules based on rooms, net classes, etc.

Thank you @cearlobe


[0] Message Index

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod