EEVblog Electronics Community Forum

EDA => Altium Designer => Topic started by: FPSUsername on June 20, 2019, 01:10:32 pm

Title: BGA fanout doesn't follow room rules
Post by: FPSUsername on June 20, 2019, 01:10:32 pm
Hello,

I am trying to fanout a BGA chip. I followed the only tutorial in existence on youtube (https://www.youtube.com/watch?v=ys00VBVbr4s). However I have the same issue as the person here (https://electronics.stackexchange.com/questions/286018/altium-15-bga-fanout-option-is-not-working-fully). Unfortunately his solution doesn't work for me. The fanout doesn't follow the rules set for the rule. In the room definition I also tried to only match the component, but that doesn't work either. What am I doing wrong?