Electronics > Altium Designer
Bottom/Top Solder Layer
(1/1)
xeon:
I am struggling with making the polygon (pink) go all the way up to the edge, instead of having clearance.
I tried changing some rules, but I couldn't figure it out with the regular copper layers, much less so with the keepout layer.
Edit: I figured it out right after posting it |O
ataradov:
Keep in mind that board manufacturers will likely have issues manufacturing a board with copper at the edge of the board. They will either ask you to modify it yourself, or charge a lot more money.
PlainName:
--- Quote ---Edit: I figured it out right after posting it
--- End quote ---
Thanks for letting us know your solution.
xeon:
--- Quote from: dunkemhigh on July 15, 2021, 03:45:45 pm ---Thanks for letting us know your solution.
--- End quote ---
Sorry.
Solution was editing this rule in Design Rules:
--- Quote from: ataradov on July 14, 2021, 09:32:40 pm ---Keep in mind that board manufacturers will likely have issues manufacturing a board with copper at the edge of the board. They will either ask you to modify it yourself, or charge a lot more money.
--- End quote ---
Yeah, I'm aware :-+ I'm putting a copper keepout there too.
PlainName:
Thanks :-+
Navigation
[0] Message Index
Go to full version