| Electronics > Altium Designer |
| Choosing footprint from library. |
| (1/2) > >> |
| flodins:
Hi I have a problem with adding items from my own library for which I defined many footprints. On the schematic always lands with a default value, unless I select the Place but it is too much clicking. If you add the built-in library, this problem does not occur I can grab a footprint that interests me and this will be set on the schematic. Do you know any solution? Something had to switch in my library? I think that the movie clearly shows all http://flodins.info/footp.mp4 |
| thmjpr:
Weird, don't see that problem in AD9.3. Is this AD10? All I can think is create a new library project, copy a part over, compile/install and see if it persists. |
| flodins:
this is AD9 |
| armandas:
Did you specify the correct footprint in your schematic library? |
| flodins:
yes, you can see that when click place it works, only grabing from my libraries does not work grabing from build in librares is ok |
| Navigation |
| Message Index |
| Next page |