Electronics > Altium Designer

Choosing footprint from library.

(1/2) > >>

flodins:
Hi

I have a problem with adding items from my own library for which I defined many footprints. On the schematic always lands with a default value, unless I select the Place but it is too much clicking. If you add the built-in library, this problem does not occur I can grab a footprint that interests me and this will be set on the schematic.

Do you know any solution? Something had to switch in my library?

I think that the movie clearly shows all

http://flodins.info/footp.mp4

thmjpr:
Weird, don't see that problem in AD9.3. Is this AD10?

All I can think is create a new library project, copy a part over, compile/install and see if it persists.

flodins:
this is AD9

armandas:
Did you specify the correct footprint in your schematic library?

flodins:
yes, you can see that when click place it works, only grabing from my libraries does not work grabing from build in librares is ok

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version