« previous next »
Pages: [1]   Go Down

Author Topic: Altium rules: discrete drill sizes / available tool table  (Read 1135 times)

0 Members and 1 Guest are viewing this topic.

Offline owieccTopic starter

  • Frequent Contributor
  • **
  • Posts: 317
  • Country: dk
    • Google scholar profile
Altium rules: discrete drill sizes / available tool table
« on: October 14, 2019, 07:46:06 am »
Can I create a rule in Altium that will only allow specific drill sizes? We have a small CNC and it would be nice if we can only design with the tools we actually have.
Logged
 

Online T3sl4co1l

  • Super Contributor
  • ***
  • Posts: 22387
  • Country: us
  • Expert, Analog Electronics, PCB Layout, EMC
    • Seven Transistor Labs
Re: Altium rules: discrete drill sizes / available tool table
« Reply #1 on: October 14, 2019, 11:25:08 am »
Sure. I think you will need to create a rule for each drill size though.

Do you use rivet vias or something?  Keep in mind their finished i.d. is quite a lot smaller than drilled!

Tim
Logged
Seven Transistor Labs, LLC
Electronic design, from concept to prototype.
Bringing a project to life?  Send me a message!
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee