EEVblog® Electronics Community Forum
Electronics => PCB/EDA/CAD => Altium Designer => Topic started by: screamindaemon on October 30, 2014, 05:46:38 pm
-
Hi all. First time posting here. From my searches here there is some good experience to be shared.
I have come across an issue with Altium 14. Whenever I try to generate NCR files now, I am getting 2 board edge routes generated on my board defined edges. Please see the attached file.
I have highlighted the correct board edge rout, but Altium is generating a second route inside the board.
Has anybody else run into this issue? Does anybody know how to fix it?
I have been using Altium 10 up to this point, and recently upgraded. There are a few changes now that are very frustrating.
Thanks in advance for your help.