Electronics > Altium Designer

Irregularly shaped pads

(1/1)

johndoe1395:
According to altium wiki (http://wiki.altium.com/display/ADOH/Creating+a+Custom+Pad+Shape), you can create custom shape pads by using various design objects to create the shape, then place a small pad inside to define the connection point. I created a custom footprint and did exactly that however the DRC shows errors at those points. What am I doing wrong? Is there any other option I need to check?

Thanks :)

free_electron:
that's normal. when pushing the netlist these bject do not get tagged.
run the DNU command. ( Design , Netlist , Update primitives from .. drat cant rmeeber what ti reads on themenu. the keyboard shortcut is DNU in the pcb editor

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version