EDA > Altium Designer

Overstanding Components!?

(1/1)

x18:
hi,

how do I design pcbs with overstanding components? like the one in the picture without getting  an error at the design rule check?
what do I have to do with those overstanding components to create a clean layout?

greetings.

JuKu:
You either ignore the error or make a rule that targetes just that component or footprint.

shadewind:
Seems like your component is outside of its room. Expand the room to extend beyond the board edge. It seems like this is what causes the error.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version