Electronics > Altium Designer

Pad Definition Troubleshooting in 4-Layer Stack Up

(1/1)

MuriTheMyth:
Hi folks,

I hope you are well. I'm beginner in AD and this is the first 4 Layer board I'm doing.

I've defined square pad for the 1st pin of the header footprint in the footprint library. Though, only the top and bottom layer correctly followed the defined shape (see screenshots). I'm wondering what happened here.

Thank you very much to anyone who helped.

Sincerely,
Muri

Someone:
Layer type, planes don't use pads.

MuriTheMyth:
Problem solved! Thank you so much!

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod