Electronics > Altium Designer

Placement rules

(1/1)

tszaboo:
I've noticed 1-2 versions ago, that there are new placement push and shove rules applied. So I cannot place components to close to each other. And it still applies, after I turn off the rule. It seems to be completely broken with anything that is rotated by 45 degrees.
How do I make it stop?

thm_w:
Can you show a screenshot?
Are you using a 3D body for the part to correctly define it?

tszaboo:

--- Quote from: thm_w on November 23, 2021, 09:48:13 pm ---Can you show a screenshot?
Are you using a 3D body for the part to correctly define it?

--- End quote ---
It would probably be a video.
I have 3D model for each part.

tszaboo:
Found it, this was driving me crazy. It's in: Interactive routing/Dragging/Component pushing
This is not routing, this is component placement! :wtf:

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version