Hi all
I have been using Circuit Maker for a while and a issue that caused so many problems a few years ago started again.
The software crashed and had a "catastrophic failure" and this basically destroys the project.
You can't even go back reversions to restore working files.
I have pulled the files into Altium Designer and they open.
But saving the schematic takes 5 mins each time.
Any ideas?
[edit]
So one of the components in the schematic was the issue.
Normally the schematic file is like 300KB but this one component was making it 6MB.
Removing it solves this issue.
[edit2] now Altium crashes and CM just fails to download.