« previous next »
Pages: [1]   Go Down

Author Topic: Locking wires onto nodes  (Read 5296 times)

0 Members and 1 Guest are viewing this topic.

Offline cksaTopic starter

  • Regular Contributor
  • *
  • Posts: 69
Locking wires onto nodes
« on: October 12, 2012, 09:11:37 am »
I don't know how i did it...but now on my altium designer...when i wire up two component pins....then move the component...the wire doesn't stay attached to the component pins :( I do not know which altium option/setting/preference that adjusts this. I want to move the component, and have the wires "tack on" to it and move with it.

Any ideas?

Thanks.
Logged
 

Offline cksaTopic starter

  • Regular Contributor
  • *
  • Posts: 69
Re: Locking wires onto nodes
« Reply #1 on: October 12, 2012, 09:45:27 am »
SOLVED:. Need to check "Always drag" in the Schematic Editor Preferences.
Logged
 
The following users thanked this post: dstraight

Offline free_electron

  • Super Contributor
  • ***
  • Posts: 8550
  • Country: us
    • SiliconValleyGarage
Re: Locking wires onto nodes
« Reply #2 on: October 12, 2012, 07:46:10 pm »
Yuck ! . that is a very annoying thing. half the tie the wires become spaghetti.
leave that option off by default and use the M-D command ( move - drag ) if you need this
Logged
Professional Electron Wrangler.
Any comments, or points of view expressed, are my own and not endorsed , induced or compensated by my employer(s).
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee