EEVblog Electronics Community Forum
Electronics => PCB/EDA/CAD => Altium Designer => Topic started by: m4l490n on August 09, 2011, 02:30:23 pm
-
Hi, I'd like to know how can I make a panel in AD S09, specifically, how do I put the v-scoring and routing paths. I've used the "Embedded Board Array/Panelize" but I don't know how to put the v-scoring and the routing paths.
Can you help me with this. THANKS!! :)
-
Talk to whoever will make the board. It may be easier if they do it.
A separate mechanical layer for routing paths is quite standard. You could use one layer each for v-score and route, or even just a different size trace (with a legend).
But your routing path should already be part of your individual board design?