Electronics > Altium Designer

v-score and rout paths placement, AD summer 09


Hi, I'd like to know how can I make a panel in AD S09, specifically, how do I put the v-scoring and routing paths. I've used the "Embedded Board Array/Panelize" but I don't know how to put the v-scoring and the routing paths.

Can you help me with this. THANKS!! :)

Talk to whoever will make the board. It may be easier if they do it.

A separate mechanical layer for routing paths is quite standard. You could use one layer each for v-score and route, or even just a different size trace (with a legend).

But your routing path should already be part of your individual board design?


[0] Message Index

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod