EEVblog > The AmpHour Radio Show

Kicad interactive bom alternatives (AmpHour #561)


Interactive bom in kicad is a nice addition and should be standard in all EDA tools!

However, there are some more third party tools. I always use VisualPlace to manually place boards.

I modified the pick&place list creator ulp for Fusion360 yesterday.

There is also SMT Assistant, which was mentioned before here on the forum, which is more limited. Doesn't use gerbers but a bitmap, not very good for big boards.

I'm sure there must be more...


[0] Message Index

There was an error while thanking
Go to full version