EEVblog > The AmpHour Radio Show
Kicad interactive bom alternatives (AmpHour #561)
(1/1)
Jeroen3:
Interactive bom in kicad is a nice addition and should be standard in all EDA tools!
However, there are some more third party tools. I always use VisualPlace to manually place boards.
https://www.compuphase.com/visualplace/visualplace_en.htm
I modified the pick&place list creator ulp for Fusion360 yesterday. https://gitlab.com/-/snippets/2188482
There is also SMT Assistant, which was mentioned before here on the forum, which is more limited. Doesn't use gerbers but a bitmap, not very good for big boards.
https://www.alciom.com/en/smtassistant/
https://www.eevblog.com/forum/manufacture/smt-assistant-software-for-handplacing-parts-free-and-awesome/
I'm sure there must be more...
Navigation
[0] Message Index
Go to full version