Electronics > Beginners
450 volts on internet coax line!
(1/3) > >>
testtube44:
Why does my oscilloscope measure 400+ AC volts on my internet coax line? Yet I short it to ground and it doesn't arc over or anything? I was scared shitless to touch it, what is causing this?
testtube44:
I'm afraid that if I touch it I will die. What is this? EDIT: its mains at 60 hz, not RF
soldar:
What happens if you connect a resistor of say 100K or 200K? Still same voltage?
StillTrying:
Going by your other posts I'd have to ask what you're connecting the scope's GND clip to!
stj:
it could be capacitive coupling to a powerline in the street because of shit earthing at the cable mux gear,
put a multimeter across the coax.
btw, is this solid, or oscillating at a fixed frequency?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod