Electronics > Beginners
555 timer oscilloscope measurements
(1/2) > >>
Gazmon:
Hi all,

I built a 555 timer flashing Led circuit in a breadboard , yes pretty basic but would really like to use my new oscilloscope to take some readings and get experience using it

It’s running at 5v , looking for tips on what and how I can use the oscilloscope to take measurements and waveforms etc

Running it from my power supply

Any help appreciated

Gazmon
GeoffreyF:
assuming everything is normal - just do it.   The best way to learn electronics is to try things and take chances.

The worst you can do is ruin an oscilloscope probe and therefore:

Oscilloscope set for 5v?
Probe 1:1
Assume the power supply ground and the oscilloscope ground are similar?   Check with a DVM to be really sure.

Gazmon:
So I can connect my ground probe to the 0v

And my probe to 5v Vcc in etc

As long as my 0v is connected to my ground probe am I ok to hook on the pulse etc that flash’s etc
IanMacdonald:
As a general principle I always use a x10 probe unless measuring millivolt levels. That way, if it accidentally gets put onto high voltage it's far less likely the scope will be damaged.  :wtf: :-+ :phew:
A habit from CRT TV maintenance days. It also means less circuit loading. When on x10 you need to compensate the probe for this particular scope otherwise your readings will be way out. The manual should tell you how.

To find the right vertical range just start at a low setting and increase until waveform is large enough to read comfortably. The scale is in volts/division so 1v/division would be suitable here. 5v/div will only give a one-division high trace.

As for grounding, depends if the PSU output is grounded or not. Generally it will not be. However, if the PSU negative is grounded then that is the only place you can attach the probe ground clip. 
TK:

--- Quote from: Gazmon on March 09, 2019, 10:52:10 pm ---So I can connect my ground probe to the 0v

And my probe to 5v Vcc in etc

As long as my 0v is connected to my ground probe am I ok to hook on the pulse etc that flash’s etc

--- End quote ---
Yes, that is what oscilloscopes are used for.  Just keep out of mains, it is dangerous.  And connect the probe to something more interesting than 5V... like pin 3 on the 555 (output), etc. to see some moving trace
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod