Electronics > Beginners
6N136 output from emitter
(1/3) > >>
ZeroResistance:
The datasheet shows pin 5 as ground and most of the reference circuits that I have seen only use the collector output of the 6N136 with a pullup connected to pin 6 (collector pin).
I have a case where I need to use the emitter as output so can I take the output from emitter like the given circuit.

So can I use the 6N137 6N136 in this mode?
Zero999:
Yes, it makes no difference whether the output is taken from the emitter or collector.
Andy Watson:
Your title says 6N136 but you asked about 6N137 -  I would say that the latter needs a power supply for its logic.
ZeroResistance:
That was a typo. this question was purely related to the 6N136.
glarsson:

--- Quote from: Hero999 on June 02, 2018, 08:17:38 am ---Yes, it makes no difference whether the output is taken from the emitter or collector.

--- End quote ---
What about the screen thing connected to the gnu/emitter pin? What problems will the screen cause when it is connected to the signal output instead of ground?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod