Electronics > Beginners

741 non-inverting showing DC output

(1/2) > >>

blinky87:
Hi all

Playing around with a 741 Inverting opamp with this configuration;

input voltage; 0.5V
Rf = 2.1k
Rin = 1k
V+ = 9v
V- = 0

and the circuit works.

However, in a non-inverting configuration, below, I have the following output;
(I have tried different 741's)


--- End quote ---


--- End quote ---

Andy Watson:
The datasheet suggests that the common-mode input range of the 741 is two to three volts less that your power supply rails. In your case this would be between 2 and 7 volts (at best!). Having one input at 0.5V is not going to work - the 741 is not in its operating range. Similar restrictions apply to the output too.


MarkF:
+1 what Andy said.  The signal inputs and output can not approach the power rails.

Offset Null:

MarkF:

blinky87:
Thank you guys. A lot of help here!

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod