Electronics > Beginners
7812 voltage output too high?
<< < (4/4)
wraper:

--- Quote from: bdunham7 on May 05, 2019, 02:45:25 pm ---As for your problem, measure the voltage (to ground) on all 3 legs of your 7812, then do the same thing on the other unit.  Then put a small load (500-1K) on the output and do it again to both. More measuring and less soldering!

--- End quote ---
Doing so is useless. There is no issue with PSU. Not to say 1k won't do much, there is 56 OHm resistor in parallel with vreg.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod