Electronics > Beginners
Adc Vref and Gain consideration(AD7715)
<< < (3/3)
tlhsglm:
I have put shunt resistor between mosfet and ground and tracked the signal with pwm increasing one by one from minimum to maximum value and start from minimum again.With this i adjusted gain to move 0volt to 2.5 volts.I will make adc's sofware tomorrow.I will not use PGA of ADC.So i will use unbuffered mode?The circuit is like this;
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod