EEVblog Electronics Community Forum

Electronics => Beginners => Topic started by: AJollet on March 27, 2017, 09:31:14 am

Title: Add a PSpice command to a schematic
Post by: AJollet on March 27, 2017, 09:31:14 am
I'd like to know how to add raw PSpice commands to a design in OrCad Capture. So far I've done everything using the menus but that's quite limiting.
Editing the output file seems complicated and it will be overwritten each time I lauch a simulation anyway.
So how can I add let's say ".IC V(1) = 0" to my design ?