Electronics > Beginners

ADG636 with 12V on pins S1A and S2A

(1/1)

LLee:
Hello im pretty new with electronics and I want to integrate ADG636 into my project.

Now I want to connect a battery of around 12V on pin S1A and S2A but I am not sure if this IC can handle this. On the "absolute maximum ratings" I can only find that power supply is maximum 13V. And that the analog and digital inputs are also something like 12V.

Would the IC die when I connect the battery?

Andree Henkel:
the IC is intended for supply of 10V (+/-5V)

13V is not intended normal operation

output voltage of "12V" batterie easily exceeds 13V during charging / full, then your IC is likely dead

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod