Electronics > Beginners
Almost completed rebuild of "old" bench grinder
cs.dk:
Complete "rebuild", seriously? :palm: ???
Mechatrommer:
You are entitled for the useless and pointless threads, the complete rebuild bullshit.. 5 flower petals for you. And for your life and will be asked why the careless care after being told just in case...
Brumby:
--- Quote from: fixit7 on July 11, 2019, 02:43:22 am ---
--- Quote from: MarkF on July 11, 2019, 02:05:39 am ---Again!
Why did you start a new thread on the same subject as the others.
All these "grinder repair" threads SHOULD be in one and ONLY one thread.
People will like to see the evolution of the project all at one place.
Keep all related content together.
--- End quote ---
I chose to do so for good reasons.
--- End quote ---
I ask in all seriousness - what are those reasons?
If we understand your perspective, we might be less critical of having one project spread over multiple threads.
TERRA Operative:
Where is the rebuild?
All I see is a single blurry blown out photo of a terribly half-painted grinder with the worst power switch install I've seen in a long time, sitting on a block of foam for some reason.
[Edit] Oh, unless this is a photo of the grinder to be restored that you haven't started working on yet?
Mechatrommer:
it was still near perfectly green https://www.eevblog.com/forum/beginners/update-grinder-switch/ now he entitled to smearing it with black goo all over. at least he's wiser if the switch we are seeing is masked with tape or something, but near the label certainly is a bad job...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version