EEVblog Electronics Community Forum

Electronics => Beginners => Topic started by: cvriv on June 23, 2016, 12:52:18 am

Title: Am I suppose to be able to select the oscilloscopes maximum memory depth?
Post by: cvriv on June 23, 2016, 12:52:18 am

I installed the upgraded license I received with the purchase of my oscilloscope and the oscilloscope said it was installed successfully, but when I was poking around I noticed that my memory depth only went to 28Mpts. I checked the installed options and I think everything is enabled. Am I missing something here? Am I just not understanding this correctly? I attached some pics.

Also, are there more options available that I'm not aware about, that if I hacked this machine I would receive?

Title: Re: Am I suppose to be able to select the oscilloscopes maximum memory depth?
Post by: tautech on June 23, 2016, 01:29:23 am

Total memory may be divided by the # of active channels.

Title: Re: Am I suppose to be able to select the oscilloscopes maximum memory depth?
Post by: rsjsouza on June 23, 2016, 02:48:08 am

As tautech said. Your picture shows the two channels active and therefore the memory will be halved.

Title: Re: Am I suppose to be able to select the oscilloscopes maximum memory depth?
Post by: cvriv on June 23, 2016, 02:49:27 am

Ok. Makes sense. Thanks.