Electronics > Beginners
Arduino Code - volts/amps/power monitor
<< < (10/10)
metrologist:
yes, indications are my actions are no help. I was getting errors right off. I reset a couple times and it was still logging after a day. I found an SD Mini card I may solder to a level shifter and go with it. I read resistive dividers on the signal lines is not acceptable for SD cards. I think that is what my LC Soft SD shield has, along with a 3.3V regulator.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod