| Electronics > Beginners |
| AT27C1024 read on a TL866CS |
| (1/1) |
| lolsteve98:
Hello all, Thank you for having me in your forum :-+ I'm currently trying to replace an EPRPOM (AT27C1024). The chip is off the board and I'm working to get a read from it using a PLCC44 to DIP40 adaptor on my TL866CS (Minipro) . However I'm getting inconsistent reads of the chip. I've tried moving the adaptor about in the DIP socket to see if it's a connection issue and also applied pressure to the top of the chip during read to check it's making sufficient contact but alas the problem still occurs. Any advice for getting a consistent result? |
| keymaster:
try to freeze it or heat it , which ever work best . (my bet is on freeze) . if you do not have a freeze spray, try normal air spray upside down. |
| bson:
And if freeze spray does work, try a contact cleaner - both on chip pins and the PLCC socket. (Use a swab, don't soak the socket.) Like DeOxit. |
| Navigation |
| Message Index |