Electronics > Beginners
Best practices for glue logic for surface mount components?
<< < (3/3)
jhpadjustable:

--- Quote from: tautech on October 27, 2019, 10:51:26 pm ---Routing for multi gate SMD packages is always the issue as you don't have the room to slip traces between pads like you do with DIP
--- End quote ---
1.27mm SOIC footprints, with 0.6mm wide pads, leaves a whole 0.57mm between pads. There's room enough for one trace on a 7.5mil design rule, and a very high probability the board house will leave the solder mask on top of it.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod