Author Topic: Can anyone help?  (Read 318 times)

0 Members and 1 Guest are viewing this topic.

Offline Usat1987Topic starter

  • Newbie
  • !
  • Posts: 1
  • Country: us
Can anyone help?
« on: October 22, 2024, 09:03:37 am »
Hello All

I just purchased the Signet stb3 demo oscilloscope training board. The reason I purchased it was to learn more about how to use the oscilloscope. Unfortunately, I need more hope than just a manual with pictures. I also looked on YouTube for training videos.

I need step by step help or at least a better training manual that goes into more detail and pictures of set-ups. Can anyone help?
 

Online BILLPOD

  • Frequent Contributor
  • **
  • Posts: 372
  • Country: us
Re: Can anyone help?
« Reply #1 on: October 22, 2024, 12:24:58 pm »
Good Morning Usat1987, Welcome to the forum.   Near the top of this page is a thread titled: Oscilloscope training class (long).   Lots of good information there and a good place to start.   Also TONS of information on the internet if you just Google the word Oscilloscope, including lots of instructional videos.   And since you don't have an actual scope yet, there are many, many threads here on the forum, about choosing one when you are ready.   Have fun,and enjoy the journey. :-+
 

Offline Simon

  • Global Moderator
  • *****
  • Posts: 18094
  • Country: gb
  • Did that just blow up? No? might work after all !!
    • Simon's Electronics
Re: Can anyone help?
« Reply #2 on: October 22, 2024, 06:01:33 pm »
 
The following users thanked this post: Solder_Junkie, MK14


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf