Electronics > Beginners
Chaining Optical Endstops
(1/1)
King_bob:
So I looted a bunch of optical endstops from a printer, and wanted to use them as limiter switches, but to do this I need to connect two of them to one output pin, as seen below. Unfortunately I can't figure out what I am doing incorrectly. When I measure signal to VCC I get a full 5V but when I chan them as seen in the diagram, I only get 2.5V. I don't understand why this is happening, nor how to fix this issue.

Any help would be appreciated.

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod