Electronics > Beginners

Charging

(1/2) > >>

Ben sage:
 Hi guys I was wondering how this old car battery charger works  because it charges battery’s with AC  and also at the 12 V setting I measure 50 V I’ve tested it it does work

Jeroen3:
As long as there is DC offset it is fine.

If there isn’t, the battery lifetime will be halved. (~2 years max)

But I suspect you‘re not probing right.

Ben sage:
It’s not DC offset there is negative and positive and I put the ground clip to the negative and the probe to positive

xrunner:

--- Quote from: Ben sage on November 29, 2019, 11:20:03 pm ---It’s not DC offset there is negative and positive and I put the ground clip to the negative and the probe to positive

--- End quote ---

You seem to be showing 50Vpp on the scope?

50 Vpp would be 25 Vpeak, and would then be 17.1 Vrms. I think the charger uses the 50Vpp into a full wave bridge, and then maybe a capacitor, so I don't think it's unreasonable. But as was said, where are you probing the 50 Vpp is the question.  :-//

Ben sage:
Here’s how I hook them up And this is what It looks like inside

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod