Electronics > Beginners

connecting speaker drivers to amplifers

(1/2) > >>

Adhith:
Hello everyone,
While reading articles and post related to audio amplifiers and speakers, I often read this note." Connect the speakers drivers first at the output before powering the amplifier".  So what is the purpose of doing it?? does leaving a speaker not connected at the output cause any damage to the amplifier circuit??
 also some suggests to use a power resistor at one of the audio outputs (rather than leaving it floating) for DIY projects using only one speaker driver.

Could anyone help me understand whats the reason for it??

Zero999:
I don't think there's any chance of damage from operating an audio amplifier unloaded, but it's possible it might not work properly. Most modern class AB designs should be fine, but there could be problems with EMI on a class D amplifier, as the filter won't be optimised for operation without a load.

Johnboy:
It's a good rule of thumb to have a load already in place for the power section to lessen the chances of overheating. In some cases a design will incorporate a "safety" for this, but if the project you're working on already suggests placing a power resistor on one of the outputs, I'm not surprised that it also specifies that you should connect a load (like the speaker) to the other as well before lighting things up.

Benta:
It's a relict from the tube amplifier days, where an unloaded output transformer could cause problems. In "solid state" or rather semiconductor amplifiers it has no place at all.
I've never seen a bipolar or MOSFET power amplifier where this could be an issue.

pwlps:

--- Quote from: Benta on January 06, 2019, 07:46:34 pm ---It's a relict from the tube amplifier days, where an unloaded output transformer could cause problems. In "solid state" or rather semiconductor amplifiers it has no place at all.
I've never seen a bipolar or MOSFET power amplifier where this could be an issue.

--- End quote ---

I don't know for the audio domain amps but in RF it is a known issue at high power, even with solid state (power MOSFET) devices: without a matched load the power is reflected back to the output stages causing an overvoltage.  Usually there is a protection supposed to monitor the overvoltage, yet I have seen several NMR/MRI RF power amps damaged after having been used without a proper load.   I don't have any experience with audio amps but I'm curious to understand why similar overvoltage problems couldn't happen there. 

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod