| Electronics > Beginners |
| Control two circuits with one switch |
| << < (3/5) > >> |
| 24ariel3:
well the remote controller was only an example my question is a general one assume we have two different systems is it possible to control one of the systems by controlling the other system. Another example can be controlling a BT receiver from car's stereo system, pressing 'next' on the stereo system will 'press' next on the BT receiver and will skip a song. Microcontroller/arduino may be needed but I'm not sure yet how to it |
| Karlo_Moharic:
--- Quote from: 24ariel3 on October 27, 2018, 12:58:15 pm ---well the remote controller was only an example my question is a general one assume we have two different systems is it possible to control one of the systems by controlling the other system. Another example can be controlling a BT receiver from car's stereo system, pressing 'next' on the stereo system will 'press' next on the BT receiver and will skip a song. Microcontroller/arduino may be needed but I'm not sure yet how to it --- End quote --- In that case your question is too general to be given a specific answer. |
| 24ariel3:
--- Quote from: Karlo_Moharic on October 27, 2018, 01:11:04 pm --- --- Quote from: 24ariel3 on October 27, 2018, 12:58:15 pm ---well the remote controller was only an example my question is a general one assume we have two different systems is it possible to control one of the systems by controlling the other system. Another example can be controlling a BT receiver from car's stereo system, pressing 'next' on the stereo system will 'press' next on the BT receiver and will skip a song. Microcontroller/arduino may be needed but I'm not sure yet how to it --- End quote --- In that case your question is too general to be given a specific answer. --- End quote --- Ok. let's focus on my last example it is closer to my actual problem. can we control a BT receiver from car's stereo system, pressing 'next' on the stereo system will 'press' next on the BT receiver and will skip a song. |
| Karlo_Moharic:
Give me the exact model & make of both your car radio and BT receiver. |
| spec:
+ 24ariel3 Part of your schematic from reply #8 is reproduced below. When SW2 is open would a current, Iq, of 100uA be acceptable? |
| Navigation |
| Message Index |
| Next page |
| Previous page |