Electronics > Beginners
Copper bar soldering problem
<< < (3/6) > >>
s3rkan:
Thank you all guys, I'll try all the advices. I want to make like this guy (after 2:30)

https://youtu.be/pQ53sk9ksxQ

He does the soldering with out any problem. I can screw the drain to the bar but source pins need to be soldered.
Gyro:
It looks as if he's using much thinner copper.
BravoV:

--- Quote from: Gyro on May 21, 2018, 04:13:08 pm ---Don't forget to check them with a magnet.  ;)

--- End quote ---

+1  :-+
s3rkan:

--- Quote from: Gyro on May 21, 2018, 04:13:08 pm ---Don't forget to check them with a magnet.  ;)

--- End quote ---

Sorry for this noob question, for what I'll check with magnet?
helius:
If the bars are fake (iron alloy covered in copper) they will be attracted to a magnet.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod