Electronics > Beginners
DAC circuit
(1/6) > >>
nForce:
How do we get "K" in this circuit? Is the calculation correct?

Thanks.
awallin:
didn't your teacher teach you to use units after each number?  ;D

it would also help if you'd specify the unit you want for "K"
nForce:
I think here we don't have any units. K is just a constant to get from ADC to the motor.
Benta:
Calculation looks OK. Unit is RPM/bit.
nForce:

--- Quote from: Benta on January 24, 2019, 07:29:39 pm ---Calculation looks OK. Unit is RPM/bit.

--- End quote ---

Ok Benta, if you understand, can you explain how do I get "K" and some comments about derivation?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod