Electronics > Beginners
Dead bug copper clad prototype board advice ?
<< < (5/5)
Zero999:
An ink eraser, the gritty rubbery type, is good cleaning copper clad board.

Be careful with cyanoacrylate (super glue), it gives off nasty fumes when overheated.
james_s:
I don't clean it at all unless it's contaminated with something or really oxidized. The flux cleans it right up.
tpowell1830:
If  you're doing RF dead bug style checkout W2AEW at:

https://www.youtube.com/channel/UCiqd3GLTluk2s_IBt7p_LjA

If you use copper clad, it is called Manhattan style.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod