Electronics > Beginners

Dead bug copper clad prototype board advice ?

<< < (5/5)

Zero999:
An ink eraser, the gritty rubbery type, is good cleaning copper clad board.

Be careful with cyanoacrylate (super glue), it gives off nasty fumes when overheated.

james_s:
I don't clean it at all unless it's contaminated with something or really oxidized. The flux cleans it right up.

tpowell1830:
If  you're doing RF dead bug style checkout W2AEW at:

https://www.youtube.com/channel/UCiqd3GLTluk2s_IBt7p_LjA

If you use copper clad, it is called Manhattan style.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod