Electronics > Beginners
Dealing with failure, loss of time when things blow out.
Jwillis:
Take it slow and try not to rush. If you find yourself getting frustrated take a break.
Don't be afraid use lots of flux.Lightly tin the pads first .Just tin the iron and solder from the pins outwards.You'll have to tin the iron several times .This seems to work best for me because I tend to be very shaky.A good set of magnifying glasses helps a lot.I just use a set of off the shelf 4X reading glasses and lots of light.
Don't get yourself down.I'm learning to and blow things up all the time.Fried 2 frequency generators on tube radios before I realized I should have had a small cap between it and the radio .say la vie
Navigation
[0] Message Index
[*] Previous page
Go to full version