EEVblog Electronics Community Forum

Electronics => Beginners => Topic started by: magnozo on August 11, 2016, 07:45:42 am

Title: Device sheet symbol question
Post by: magnozo on August 11, 2016, 07:45:42 am

Hello folks! I have a problem with using Device Sheet Symbols.
When I use these symbols in a new project it works fine, I have 3 instances of a symbol and all of them are created on the Pcb (REF_A, REF_B, etc.).
But when I use the same 3 instances on one of my existing projects, I have only one room created on the pcb.

Title: Re: Device sheet symbol question
Post by: magnozo on August 11, 2016, 07:53:31 am

And one more thing, the existing project was improted from PCAD, maybe that causing the problem?