Electronics > Beginners
Difference between coax cable and shielded cable
vk6zgo:
--- Quote from: tkamiya link=topic=214566.msg2741556#msg2741556 date=1571250522 8) ---I wonder if anyone with VNA would be willing to characterize a good quality shielded 1 conductor cable....? Then compare it against say RG174. Unfortunately, this is well outside of my capability.
--- End quote ---
A VNA is nice, but you can find out a lot about cables using "old school" methods.
http://users.tpg.com.au/users/ldbutler/TransLines.pdf
You can determine the cable impedance Zo, using formula [3] on page (2), with test setup as per figure [8] on page (4)
Lloyd goes on to describe other methods, which can determine Zo, & velocity factor of an unknown cable.
Alan, w2aew looks at pulse testing of cables in this video:-
& revisits the theme in these two videos:-
soldar:
--- Quote from: vk6zgo on October 17, 2019, 12:49:28 am ---Single conductor shielded cable used to be common, but maybe, not so much now.
That "single" conductor is not concentric with the shield, as in coaxial cable, & the cable's impedance is not well specified..
--- End quote ---
Well, it is loosely concentric but with very loose tolerance.
I remember, decades ago, when I was more into radio and was always messing with microphones that I could only get single conductor shielded cable which was a problem because I needed a second conductor for the PTT pushbutton. You could buy twin shielded cables for stereo audio but not two wires with a single shield. Whenever I found that cable I would buy it.
That kind of shielded cable is fine for audio and relatively low frequencies but no good for RF. In fact, one of the oscilloscope cables I have is plain, very thin, shielded cable and it works fine at low frequencies.
SL4P:
Remember there are braided and foil wrapped coax cables, along with solid and stranded centre conductors.
Choosing the right connectors is important for this as well as impedance.
Navigation
[0] Message Index
[*] Previous page
Go to full version