Electronics > Beginners
Diptrace and Pin Swapping
(1/1)
admiralk:
I am building a little keypad and wanted to clean up the layout a bit by rearranging the pins on the header. Instead of 1, 2, 3, 4, 5, I assigned the pads as 1, 4, 3, 5, 2. When I update the layout, I get 1, 5, 3, 2, 4, however.

Would I be OK to just ignore what Diptrace is telling me? I am already pretty much ignoring the ratlines as Diptrace does not seem to recognize the internally connected pins on the buttons. Or, is there something else I should be doing?

Mark this as stupid question #1, for me, on this forum.  :D
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod