Electronics > Beginners
Discrete Regulated power supply
<< < (13/13)
not1xor1:

--- Quote from: Cliff Matthews on March 07, 2019, 12:50:01 pm ---@not1xor1 - If he adds one or 2 more, shouldn't he at least upgrade the PNP driver to a TIP42c or similar?? (Ic = 6a)

--- End quote ---

 :scared: NO because mike_mike wrote:

--- Quote ---I don't need more output current, just more power transistors in parallel.
--- End quote ---

so the current required by the PNP driver would be approximately the same
the same because the maximum output current doesn't change, is just split among more BJTs
approximately because hFE vs. IC is not flat
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod